DN Charger & Lipos ... Is it OK ?

[jurassic5]

Hi everyone,

I have this DN charger

http://www.readyheli.com/DN_Power_Micro_Controlled_LiPo_Li_Lon_G2_Balance_C _p/dncharger.htm

I order two lipos for my planes, just wondering how much could I charge them (I can go from 0.2 to 2.0A) to be in the "standard".

For this one :

ZIPPY-R 2500mAh 21-35C 4S1P
Spec.
Minimum Capacity: 2500mAh
Configuration: 4S1P / 14.8v / 4Cell
Constant Discharge: 21C (Minimum)
Peak Discharge (10sec): 35C
Pack Weight: 259g
Pack Size: 125 x 41 x 28mm
Charge Plug: JST-XH

and this one

ZIPPY 2200mAh 3S1P 20C
Spec.
Capacity: 2200mAh
Voltage: 3S1P / 3 Cell / 11.1v
Discharge: 20C Constant / 25-30C Burst
Weight: 168g (including wire, plug & shrink wrap)
Dimensions: 100x34x27mm
Balance Plug: JST-XH
Discharge Plug: T-Connector (Deans Type)

Thanks a lot,

Cédric

[zen97713@zen.co.uk]

Hi everyone,


ZIPPY-R 2500mAh 21-35C 4S1P
Spec.
Minimum Capacity: 2500mAh
Configuration: 4S1P / 14.8v / 4Cell
Constant Discharge: 21C (Minimum)
Peak Discharge (10sec): 35C
Pack Weight: 259g
Pack Size: 125 x 41 x 28mm
Charge Plug: JST-XH

and this one

ZIPPY 2200mAh 3S1P 20C
Spec.
Capacity: 2200mAh
Voltage: 3S1P / 3 Cell / 11.1v
Discharge: 20C Constant / 25-30C Burst
Weight: 168g (including wire, plug & shrink wrap)
Dimensions: 100x34x27mm
Balance Plug: JST-XH
Discharge Plug: T-Connector (Deans Type)

Thanks a lot,

Cédric

The 2500Mah batt at 1C can be charged at 2.5A and the 2200mAh battery at 1C can be charged at 2.2A. To answer your question you can charge them both at 2A ! The ballance connectors are compatible with the DN power G2 so you should have no problems. Just make sure the black lead comming out of the battery matches with the negative on the charger. If it doesn't then use the reversing adapter that came with the charger.