HDX500SA V2 (Rotorworkz version)

[billyzelsnack]

Is this available yet? The scroller at the top of HD says HDX500SA V2 is available now. Clicking on it takes you to the normal HDX500SA page. Is this the V2 version? Is the V2 the same as the Rotorworkz version? It's all very confusing.

[lonelasso]

Is this available yet? The scroller at the top of HD says HDX500SA V2 is available now. Clicking on it takes you to the normal HDX500SA page. Is this the V2 version? Is the V2 the same as the Rotorworkz version? It's all very confusing.

Well...Charlie (Rotorworkz) works for HD now and I noticed on the new frames the RZ logo laser cut in the lower rear (below servo cut-out)...so I wouldnt worry too much ;)

-Dave
http://www.rcgroups.com/forums/showthread.php?t=728980

[billyzelsnack]

Cool.

I went back and all of a sudden a new image showed up..

http://www.helidirect.com/images/helicopter_kits/HDX500SA-2.jpg

Though I just went back again and it was back to the old one. haha. I guess it is "just" coming out now. I wonder if there will be a special deal celebrating its release.

[billyzelsnack]

Also.. Just wondering about A123's in this guy. Would the required cell count fit and perform well?

[lonelasso]

Also.. Just wondering about A123's in this guy. Would the required cell count fit and perform well?

A123s *might* be ok....weight could be a concern though. Plan to test a 5S pack soon :)