New DX7- no servo movment.

[Termite]

Just received my new DX7, I bound the receiver to the transmitter, everything seems fine, plug in the servos and nothing :dontknow

I didn't set up all of the menus but I did do the basic set up ( i.e. model name, type, swash config, ect.)

Anything I should check?

[Pinecone]

Are the servos plugged in the right way?

[Termite]

I'm pretty sure but I'll double check

[Termite]

I figured it out...it was not bound correctly. When I first did it the receiver flashed once, when I did it over again it flashed rapidly and once bound correctly it worked fine....go figure. ;)

[Pinecone]

You need to hold the bind buttonand wait until the LED(s) in teh Rx come back on solid.

They start by flashing when you power up. Then they flash at a different rate, then they go off, then the come back on solid. Binding is complete.