fitenfyr
05-25-2005, 01:43 AM
Anybody from the latest batch notice that the frames are really not cut cleanly?
I had to hand mill out the motor mount slots on the lower frame to get the bolts to go through smoothly and allow adjustment.
Generally the Right side frame and lower plate appear as if the mill bit was dull when they were cut. Lots of "caked" in carbon dust and the edges are ragged.
I have to say that overall this is not a fun build at this point.
It is not nearly as clean a build as my Ion or Extreme were.
Lot's of places where you have to read and re-read especially when dealing with the front/rear engine mount options and the diagrams are too small in a lot of places.
I think ESPECIALLY on the options pages they should be full page diagrams so you can see the slight changes regarding the setups.
I am still favoring my Bergen at this point. :wink:
I had to hand mill out the motor mount slots on the lower frame to get the bolts to go through smoothly and allow adjustment.
Generally the Right side frame and lower plate appear as if the mill bit was dull when they were cut. Lots of "caked" in carbon dust and the edges are ragged.
I have to say that overall this is not a fun build at this point.
It is not nearly as clean a build as my Ion or Extreme were.
Lot's of places where you have to read and re-read especially when dealing with the front/rear engine mount options and the diagrams are too small in a lot of places.
I think ESPECIALLY on the options pages they should be full page diagrams so you can see the slight changes regarding the setups.
I am still favoring my Bergen at this point. :wink: