Speed stick 3D
01-26-2008, 11:08 PM
well i am rebuilding the swift so i just need to sell this baddd.. all it needs is a belt..includes the following..
T-Rex 450 Xl
CCpm upgrade
3 Cirrus Ultra high speed 9 g servos
1 walkera High speed tail servo
1 Mutiplex 480 4D heli motor
13 T pinion
Align 25 Amp esc W heat sink
Align Fiber 325 blades (yellow)
Upgrade carbon fiber vertical fin
Electron 6 reciver (cased removed for less weight)
Ch 38 Crystal
Walkera G0017 Heading Hold Gyro
Pollyquest 25 C 2200 3 cell li-po
This was a budget T-rex and i was amazed how well the tail held for a walkera gyro.. it can do 3D fine just not very HARD.. loops, rolls, inverted and flying around this is a great heli.. all it needs is a belt and its a complete heli. The li-po is getting a little tired but it still works fine..It was in a small crash and didnt do any damage to the cells but the shrink covering cracked so i recovered it in electrical tape... I need to sell this for swift parts... 220.00 shipped oBo
Thanks Speed stick 3D
T-Rex 450 Xl
CCpm upgrade
3 Cirrus Ultra high speed 9 g servos
1 walkera High speed tail servo
1 Mutiplex 480 4D heli motor
13 T pinion
Align 25 Amp esc W heat sink
Align Fiber 325 blades (yellow)
Upgrade carbon fiber vertical fin
Electron 6 reciver (cased removed for less weight)
Ch 38 Crystal
Walkera G0017 Heading Hold Gyro
Pollyquest 25 C 2200 3 cell li-po
This was a budget T-rex and i was amazed how well the tail held for a walkera gyro.. it can do 3D fine just not very HARD.. loops, rolls, inverted and flying around this is a great heli.. all it needs is a belt and its a complete heli. The li-po is getting a little tired but it still works fine..It was in a small crash and didnt do any damage to the cells but the shrink covering cracked so i recovered it in electrical tape... I need to sell this for swift parts... 220.00 shipped oBo
Thanks Speed stick 3D