Copterx 200

[MULIKOW]

Received my Copterx 200 yesterday and started the build. This is where im at right now. Using the 20-34-110 ARC brushless motor, logictech 2100t, 910 thunderpower lipo, phoenix 35 amp esc, and towerpro 9g servos.
Should have it up and flying on Youtube in a day or two.

[MULIKOW]

pics

[PTFlyer]

ok.......I'm very courious how this little heli flies.......hope it's not another hdx300, that would be a real disapointment....

great price point though....please post after you get it in the air and let us know what you think.....go easy , looks like spare parts might be a bit hard to find at the moment.

[dizzymarkus]

Howdy Im close also lol -- waiting on 3 orders to complete it. The spare parts will be available in March due to procesing and the Chinease New year :0)

MULIKOW---
You realize this is a portly little heli -- weighs the same empty as the Gaui 200 fully loaded, so I decided to go the lightest route I can. The motor is reasonible in (39g) weight at 3100kv plus ESC wieght
I was able to find (someone shared it) a 4200kv motor (xmseller) and esc that weighs in at your motor wieght lol -- If you find you need the link I would be happy to foward it over to you. The 9 g servos total 36g's -- again a little weight here and there to lose is a good thing. The ones I found are 5g with high torque :0) totaling 20g's. The gyro I am still deciding .

I did however misplace the tail blades -- would you know the MM on them or where to order some more ? Some fellas measured roughly 50mm but I am unable to find some. I may have to cut some down from HBKII or trex plastics :0(

Thank you
Markus

PS A few sizing pictures lol -- all in the palm of my hand:0) -- the last is next to an axe cp and a mx450xs

[jaimerioco]

Hello,
I bought a copterx 200 but it has no power enought to do 3D flights. So I changed the motor for a mistery 4200kv but the main shaft bends and the copter fells down.
The manufacturer has recommended me the V2 shaft. What do you think?? Wich motor do you recommend me to do 3D flights?? Do you know somebody that uses this motor with V2 shaft with no problems??
Thank you!!