View Full Version : NEW CNC Flybar Seesaw Holder T version 2 - HDX500SE
booger
01-31-2008, 06:55 PM
What is the change in this from the v1?
666yeti666
02-01-2008, 03:01 AM
I understood it is slimmer , so there's no binding of the linkages. The original one is thicker and also heavier without the need for it ...
Ticidytoc
02-01-2008, 11:48 AM
I'm not 100% sure, but I believe Charlie had the holes moved to change the geometry in the head also.
I hope they fix the hole diameter for the bearings. V1 holes were very loose. I had to use a thin layer of BB cold weld to fix that.
booger
02-01-2008, 02:10 PM
I sent a support ticket and this is the answer I received
Robert, thanks for contacting the HD helpdesk! I was just finding out the difference for another customer when I saw your ticket pop into the queue!
Either Seesaw will work with current flybar cage...the main difference it that it was made a little narrower and lighter...basically changed to save a little weight in the head....
crash1000
02-10-2008, 08:19 PM
so its only for the weight? how much is it saving? 200g :)
Ticidytoc
02-11-2008, 07:22 PM
yeah I'm sure its not much, but if it helps keep this heli lighter than a trex500 then why not?