View Full Version : 14mz Switch U/s
Hi
My 14mz Switch Function Are All Inoperate
Anyone Know What Can I Do??
DavidH
02-01-2008, 10:34 AM
Have you been into the service menu to change the region code? The reason I ask is I see in one of your other posts that you was asking about doing this.
David
Yes, I Did. And What Can I Do Now??
DavidH
02-04-2008, 01:34 PM
Sounds like you went thru the stick calibration program and calibrated the sticks to have no movement. You will need to recalibrate the sticks with the correct procedure.
That is one of the problems of going into the service menu if your not familiar with how it works and what to do.
David
because I bought mode1 14mz, after I modify hardware to mode2, all switch function were u/s
do you have the correct software and calibration procedure for me??tks!!
DavidH
02-05-2008, 11:44 AM
When your in the service menu. The calibration program for the sticks, switches. sliders, is in the service menu. You will just have to scroll thru till you get to it and then do the calibration.
Since you changed the throttle function to the opposite side, you will definitely need to calibrate the sticks
David
When your in the service menu. The calibration program for the sticks, switches. sliders, is in the service menu. You will just have to scroll thru till you get to it and then do the calibration.
Since you changed the throttle function to the opposite side, you will definitely need to calibrate the sticks
David
tks, I fixed it after I recalibrate all sticks and switchs.