View Full Version : 600N Pro with Align 2 in 1 Futaba 611 Gyro
CAMOMAN
02-03-2008, 12:40 PM
I noticed the output voltage of the align.2 in 1 is around 5.7 volts.....The 611 manual says max volts is 6.0 for Gyro....I have somewhere read the 9256 can't handle 6 volts........ok my question is Does the Gyro amp drop the voltage down for the servo or am I gonna have to have a step down regulator.....I don't want to burn this expensive Gyro Servo combo up.....any suggestions and what do you guys do...
Thanks.
byHISgrace
02-03-2008, 01:06 PM
Use a step-down between the gyro and the servo.
invertmast
02-03-2008, 01:24 PM
Use a step-down between the gyro and the servo.
this is what i do
Street Flyer
02-03-2008, 01:29 PM
Put the step down between the gyro and tail servo.
brgsstm
02-04-2008, 03:26 AM
this is what i do
me too
aussiemick
02-04-2008, 06:44 AM
me three
Mick
Timberwolf
02-04-2008, 09:11 PM
I noticed the output voltage of the align.2 in 1 is around 5.7 volts.....The 611 manual says max volts is 6.0 for Gyro....I have somewhere read the 9256 can't handle 6 volts........ok my question is Does the Gyro amp drop the voltage down for the servo or am I gonna have to have a step down regulator.....I don't want to burn this expensive Gyro Servo combo up.....any suggestions and what do you guys do...
Thanks.
Here's the Align one I used......
http://www.readyheli.com/K10333A_5_1V_Step_Down_Voltage_Regulator_p/k10333a.htm