DX7: ele-aile mix with throttle problem

[uragano47812]

Hello i have a DX7 and a Stratus. I don't have a gov and I want to put a mixer for ELE-THROTTLE and AILE-THROTTLE.

But i see that when i give full aile or full ele the throttle channel goes over the limit and throttle servo makes noise.

How can i setup it in the right way?

Thanks

[uragano47812]

No one? :(

[bigdog 714]

I have DX6 and it has programable mixing (A), I have a Kinetic .50 that uses a 40% throttle mix with ail, ele, and rud. The throttle is the slave channel and the others are the master, so the aileron mix is A21, aileron-throttle, with a 40%+or- mix value. I have a DX7 on my bench for a T-Rex 450 build I just finished, I only consentrated on the eCCPM set up and havn't checked out the other available mixes yet, but if its on the 6 I know its better on the 7

[dos boss]

What percentages are you setting and which do you have set as master?

[bigdog 714]

Since I am adding 40% throttle, the throttle is the slave, aileron ch2, elevator ch3, and rudder ch4 are the master, since it is primarily a 3D setting I assign the function to flight mode 2. To set the mix value you have to move the stick for the master in each direction and increase the value to +40% for both directions. I got my Kinetic .50 used and its in rebuild, and won't be finished untill Friday, I havn't had a chance to even bench test it yet, I have set up the radio, but the rest is still theory at the moment.