Dustman
02-09-2008, 09:39 AM
I used a T7CAP Futaba tx, plugged the brushless esc into ch5 of the blade 3 n 1, and slaved ch5 to ch3 on the radio. Plug the tail rotor in where it normally goes, and leave the main motor connection unused. It is totally a different Blade CP. I now can adjust every function of the little bird, and I didn't have to buy the little brushed to brushless converter. Gyro is turned off in the radio, and let the gyro section of the 3 in 1 contoll the tail rotor like always. I built one with the standard single tail rotor motor, and one with the double motor setup. The motors of course run cooler in the double set up. The cool thing about this setup is the complete control over pitch and rpm curves. Talk about available rpm! You can set this sucker on the moon! Hope this was helpful. :-)