FINALLY a fix for all the logo 10 and 14 main gears

[Speed stick 3D]

well after i got my logo 10 and i was using a Z30 on 6 cell kong power.. i stripped the main gar twice when i went into idle up... I got the measurments of the swift 16 main gear and it was identical size.. it has very corse teeth and will not strip.. i had to change the tail drive gear out also becaue the stock one has fine teeth also... i can go into idle up no problem and my head speed is 2450.. i am also running a 9 tooth pinion.. here are some pics of the heli and the main gear..

Thanks Speed stick 3D

here is the setup...

Logo 10
Hitec 225 MG servos (cyclic)
Century 600 + motor
Align 75 Amp esc
Futaba Gy 601
Futaba 9251 tail servo
2 Kong Power 2200 25 C 3 cell in series (6 cell 2200)
MAH 500 mm CF blades (These are nice)
Swift CNC Grips
Swift CNC Head Block
Swift CNC antirotation pin unit
Swift Swash 120 degree
Futaba 7 ch reciver
Futaba 7 CHPS
4 cell reciver pack
Deans whip antenna

Costom Flybarless no stabalization.. yes it does fly and it does 3D...

Thanks

[OICU812]

Yea the Swift main gear is a "copy" of the Mikado Logo 16 main gear, several years ago Century decided to copy it. Several people including myself used the Logo 16 gear in the Logo 14s for the high power systems. The Swift gear is abit different plastic however, abit more on the brittle side.

[fougasse32]

hello

what kind of tail drive gear did you use? the swift one?

Christian

[shihan]

I would like more info on this setup . can you give complete details .and part numbers. thanks . I need to do thid mod.

shihan

[Speed stick 3D]

yes i used the swift tail drive gear and 9 tooth pinion gear.. i had to make the hole on the motor mounting plate a little bigger because the swift pinion is alot bigger than the stock one..

Thanks speed stick 3D