raptor 50 throttle/pitch curves help/setup

[motoxmaniac93]

hi guys i need some help setting up my throttle curves and pitch curves for a raptor 50
right now mine are,

Pitch curves
Normal: 25-55-75-INH-100
Stunt 1: 0-48-75-90-100
Stunt 2: 0-INH-50-INH-100

Throttle curves
Normal: 0-20-40-62-85.5
Stunt 1: 100-50-42-50-100
Stunt 2: 100-INH-50-INH-100

Im using an os 50 hyper btw

Could some one give me some good throttle/pitch curves for someone that is starting flips and rolls on the next gallon (done with first gallon) and so that i could go into idle up in a hover and not on the ground..

Thanks,
Alex

[WayneBrown]

First off, see if you can find local help for the eyes on/hands on on the setup.
Reset your curves to linear (0-50-100, and 100-50-100)
adjust your EPA back to 100% at both high and low stick, manually adjust the servo arm AND the throttle arm to get as close to full travel each direction as possible before adding to the EPA's.
Set high/ low limits in EPA
at midstick, set the sub-trim to hit the center mark on the carb.
test hover and adjust to desired headspeed with subtrim ONLY, do not change curve at this point. Do this for all flight modes.
At this point, you should be able to flip between normal, idle 1 and 2 without having an RPM change at midstick. Test hover to verify, or look at the servo when flipping between modes.
enter Throttle curve menu, switch to idle up and test with inverted hover and punchout (local help if you can't master this). Adjust midstick value up/down as required to keep from overspeeding.
Enjoy.

[BarracudaHockey]

Wayne is right but if you are going it alone
http://www.raptortechnique.com is invaluable.