Throttle hold on a DX7 in Reflex

[AusAnt]

I have been using my DX7 on Reflex for some time now and really like it.

Only thing is, I can't work out how to program my throttle hold switch to kill the throttle (ie. autorotation channel). When I do the channel assignment, if I flick the throttle hold switch, it doesn't register anything. So for now I use the Aux 2 switch for autorotation, but this doesn't teach me the real location of switches I use in real life.

Any ideas on how to set it up?

Thanks,
Ant

[mewsikman]

unfortunately you can't....... I wanted to do it but Reflex just doesn't allow it.......

[jaron]

It works on mine (5.0.3) but I'm not sure anymore how I've done it.

The channel assignment could be the key. Look at my photo and give it a try.
Don't forget to activate Throttle Hold on the DX7.
I've got a flat throttle curve for NORM at 0%, ST-1 at 80% and ST-2 at 100%.

Now Channel 1 in the Reflex channel display should act according to the flight mode and the throttle hold switch.

Let us know if that solved your problem.

[widower]

I noticed that you don't have the throttle assigned. If that's the case, you could set your throttle curves to always send 100% and if throttle Hold is on, then throttle curve at 0%. Then assign your throttle channel to the autorotation channel.

[AusAnt]

Thanks guys for the replies,

I did get it worked out finally. Firstly I didn't have throttle hold activated for the model I use in the tx for the sim, then it worked but it sent collective to 0 and left throttle running. So I reversed those two channels in the assignment, and now everything is perfect. It works exactly like it works on my real helis.

Ant