X9303 2.4 Gear/Aux3 output?

[Joey.S]

Hey guys,

I'm trying to setup my x9303 2.4/R921 Rec so that I can use the gear switch on Aux3. I have a helicommand and what i'd like to do is use the gear switch to give me a zero when switched up and 100% switched down so I can set the trim on the HC while in a hover. I have the Aux2 switch on Aux4 of rec working good. Pos 0=0, Pos1=30,Pos2=65 for the HC sensitivity. I have no other open spot on the receiver because the gear is gyro sens and Aux2 is for my revmax setting, all working good.

So i'm I missing something here, I just want to use my gear switch with Aux3 of the receiver:confused:

Thanks
Joe

[blackbear]

why wud'nt u just use the aux3 lever on the right hand side of ur tx and set the limit in travel adjust,reverse the channel if u want it to operate backwards.from what i see there's no way to control aux3 channel via gear switch.

[WayneBrown]

program mix, use a switched channel as the master, and AUX3 as the slave output.
go back to the manual and read up the particulars, I'd end up with a migrane trying to type how to do it, but it takes less than 5 minutes to do with tx in hand..

[Joey.S]

program mix, use a switched channel as the master, and AUX3 as the slave output.
go back to the manual and read up the particulars, I'd end up with a migrane trying to type how to do it, but it takes less than 5 minutes to do with tx in hand..

Ok I will go back to the book and read the mix part over again.
Thanks for your help.

Joe

[Joey.S]

program mix, use a switched channel as the master, and AUX3 as the slave output.
go back to the manual and read up the particulars, I'd end up with a migrane trying to type how to do it, but it takes less than 5 minutes to do with tx in hand..

Hello,

I just tried it using a mix and it works great.:banana

Thank You:noteworthy

Joe