RC Instalation...Help

[1basejump]

Hello all,
I have a Knight 50 3d, and i`m running out of space with my rc instalation.
Servos went in fine, but the trouble im having is where to put my GV1 amp GY611 amp and alighn 2 in one regulator.
its getting bad when my two year old starts to mock me about it.

Any help or sugestions, pics would be greatly apreciated.

[WayneBrown]

stick the amps back to back, then stick them on the top of the radio tray, place the rx on top of them. the align battery and 2in1 can go on the bottom, you will be able to connect the lead to the glow plug. route wires away from frame sides, and use a velcro strap or two to secure it all to the plate.

[1basejump]

Thankyou very much

[Ruff]

With all the new electronic toys we are putting on the helis these days it is hard to find space.

I had the same problem with my K3D. I ended up buying another servo mount, and put it in the rear with the 601 sensor and used the stock front mount for the amp.

I mounted the battery under the flat tray, right in front of the engine, receiver on top of that plate, and the Rev Max and Carb Smart on the side of the frames. I was also able to squeeze in a AZ Regulator on the side, right over the rudder servo. (Moved that up front, off the boom)

Ruff