How to setup V-bar?

[uselessmidget]

Hey everyone i just got a logo 10 with century swift vbar head, So i was woundering how do check the pitch of the blades if theres no flybar too compare with the pitch gauge, Also are these stabilizers required?

If so are these cheaper csm ones good enough?
Do they affect 3d performance?
Which would you reccomend for 3d flight without breaking the bank?

Thanks eveyone!

[Eyefly]

Here is your new pitch gauge. Pretty inexpensive too. I have no more need for the mechanical one. It is a pain in the rear end to me.

http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=95998

The CSM system and the V-stabi do the same thing. It is very subjective here. I understand the V-stabi is easier to set up. I have the CSM which is a but less expensive. If you dont do any fast flying, some folks just remove the flybar and fly with no electrical sabilization.