darkfa8
03-06-2008, 01:07 PM
http://www.g-body.org/temp/e80.jpg
The new Century Electron Brushless ESC's come easy to program with 4 flying modes. Just throttle up before plugging in your battery to enter programming mode, then throttle down upon selecting a mode indicated by the number of beeps (1 beep = mode 1, 2 beeps = mode 2, etc...) Disconnect the battery, wait a few seconds, plug in the battery and start flying. The ESC features governor mode and non-governor mode for helicopters and airplanes. Soft-start when throttle has been in down position for longer than 15 seconds.
Features:
Now includes Ferrite Ring!
Easy to Use: 4 Flying Modes
Supports Quick Throttle Response
Supports Linear Throttle Output
Supports Stable RPM Control
Supports Compatibility with Most Brushless Motors
Supports High Speed Brushless Motor
2-Pole Brushless Motors up to 240,000rpm
6-Pole Brushless Motor up to 80,000rpm
12-Pole Brushless Motor up to 40,000rpm
Built-in Heat Sink
Built-in Throttle Calibration Function
Built-in Soft Start Function for Helicopter
Built-in Governor Function for Helicopter
Built-in Auto Motor Timing Function
Built-in World Famous Brand MOSFET with High Quality, Reliability & Low Impedance
Two Stage Protection Soft Cut then Hard Cut
Low Battery Protection for LiPo/LiOn Battery
High Temperature Protection for ESC Body
PWM Frequency............................. 12Khz
BEC Continuous Output................ None
Continuous / 15-Sec Peak Current... 80A / 100A
Maximum Operation Voltage / Li-Po Cell... 25V / 6-Cell
Physical hardware limitation 30V
(If CNE480 utilizes anything beyond 6 cell Li-Po or 25V, the power source may cause serious damage to the ESC and will not be covered under warranty)
Low Battery Protection
Soft Cut Voltage....... 2.9V per Li-Po Cell
Hard Cut Voltage..... 2.6V per Li-Po Cell
High Temperature Protection
Soft Cut Temperature..... 110°C / 230°F
Hard Cut Temperature... 120°C / 248°F
Weight: 83.96g
Body Dimensions: 80mm x 30mm x 14mm
Wire Length: 142mm
Servo Lead Wire: 255mm
This ESC was used to test a 550-size rc heli for several flights. It is in excellent condition, with male Dean's connector. Sold as-is. $60 shipped in the USA. Paypal accepted if you pay the fees.
The new Century Electron Brushless ESC's come easy to program with 4 flying modes. Just throttle up before plugging in your battery to enter programming mode, then throttle down upon selecting a mode indicated by the number of beeps (1 beep = mode 1, 2 beeps = mode 2, etc...) Disconnect the battery, wait a few seconds, plug in the battery and start flying. The ESC features governor mode and non-governor mode for helicopters and airplanes. Soft-start when throttle has been in down position for longer than 15 seconds.
Features:
Now includes Ferrite Ring!
Easy to Use: 4 Flying Modes
Supports Quick Throttle Response
Supports Linear Throttle Output
Supports Stable RPM Control
Supports Compatibility with Most Brushless Motors
Supports High Speed Brushless Motor
2-Pole Brushless Motors up to 240,000rpm
6-Pole Brushless Motor up to 80,000rpm
12-Pole Brushless Motor up to 40,000rpm
Built-in Heat Sink
Built-in Throttle Calibration Function
Built-in Soft Start Function for Helicopter
Built-in Governor Function for Helicopter
Built-in Auto Motor Timing Function
Built-in World Famous Brand MOSFET with High Quality, Reliability & Low Impedance
Two Stage Protection Soft Cut then Hard Cut
Low Battery Protection for LiPo/LiOn Battery
High Temperature Protection for ESC Body
PWM Frequency............................. 12Khz
BEC Continuous Output................ None
Continuous / 15-Sec Peak Current... 80A / 100A
Maximum Operation Voltage / Li-Po Cell... 25V / 6-Cell
Physical hardware limitation 30V
(If CNE480 utilizes anything beyond 6 cell Li-Po or 25V, the power source may cause serious damage to the ESC and will not be covered under warranty)
Low Battery Protection
Soft Cut Voltage....... 2.9V per Li-Po Cell
Hard Cut Voltage..... 2.6V per Li-Po Cell
High Temperature Protection
Soft Cut Temperature..... 110°C / 230°F
Hard Cut Temperature... 120°C / 248°F
Weight: 83.96g
Body Dimensions: 80mm x 30mm x 14mm
Wire Length: 142mm
Servo Lead Wire: 255mm
This ESC was used to test a 550-size rc heli for several flights. It is in excellent condition, with male Dean's connector. Sold as-is. $60 shipped in the USA. Paypal accepted if you pay the fees.