View Full Version : How to lube the belt
dengoR
03-07-2008, 04:39 AM
I just bought a can of 3in1 Silicon spray for my 450se tail belt. However, I am not quite sure where and how I should apply this to the belt?? :arggg:
growler
03-07-2008, 05:22 AM
Firstly, be careful with a 3 in 1 spray because it can cause the belt to deteriorate over time. It's best to use a food grade silicon spray or rc car shock oil.
To apply, just spray the end of a cotton wool bud and hold it on the belt and spin the head. Apply to both the inside and the outside of the belt. Spraying directly onto the belt causes an utter mess and is totally overkill.
This only needs to be redone every 6 or so flights. I do it every weekend before flying.
Hope this helps
Neil
Skarn
03-07-2008, 03:22 PM
I run my belt loose and never lube it. I haven't had any problems to date.
A lot of people don't lube...but others do. Personal preference.
Skarn
dengoR
03-07-2008, 08:55 PM
im sure i read on here somewhere that the WD40 brand 3in1 "Silicon" spray would be fine for tail belts? wont be putting it on if there's a chance of deterioration :thumbdown:
shaggybirdman
03-08-2008, 12:09 AM
well WD40 is a petroleum based product, and the belt is a plastic (of sorts) i'd be very cautious putting it on the belt. it won't take a week to destroy it, but i'm sure it will fail at the worst time.
dengoR
03-08-2008, 01:03 AM
i am talking about this product > http://www.acehardwareoutlet.com/(0stzs2550un2lc55yj4becaw)/ProductDetails.aspx?SKU=998044724&
isnt silicon safe for rubber/plastics?
shaggybirdman
03-08-2008, 11:58 AM
silicon is safe as far as i know, but the regular WD40 (in the blue can) will probably take longer to break down the belt than snapping the belt due to a blade strike. it will also attract dirt and dust slowly wearing out the belt, so will silicone for that matter.
dd016857
03-20-2008, 07:54 PM
guys
Oil and rubber don not mix.
Lubing the belt will kill the rubber over time , if lube is not dry then there is the issue of the oil attracting dust particle..which turns into....RUBBING COMPOUND.
This will lead to all contact surfaces wearing away quicker than normal.
My suggestion is using the lube thay use for locks..a graphite based powder..or pencil leds....works for me
regards
dan