jeff2215
03-08-2008, 06:25 PM
I had this setup working for a bit until I ran into a mishap adjusting my the gain on the AP2000i and my trims. I in the process of trimming my heli out using the transmitter trims with the AP2000i gain on 100%. I than turned the AP2000i gain to 0% which put my heli out of control and into a nose dive crash. I have fixed and replaced all what appeared to be broke and damaged including a servo or two. Is there a way to check to see if the Gyro is still working? The reason I ask is, I am having a problem getting the tail from spinning around wildly up just lifting off. I have to throw the hold switch to kill it. I have adjusted the gain from -20 to +30 on the trim 4 setting in the AP2000i, but the gyro won't seem to hold the tail. I have tried the servo trick that one member had mentioned. That didn't work. I am wondering if I have a bad gyro or if I have it set up wrong. I have the gain (single yellow wire) going into channel 4 on the AP2000i and the others going to the servo and to channel 4 on the receiver. It is not in HH mode. The red light is on (solid) on the gyro. I just can't figure out why the tail is out of control and not responding like it should. I am able to control the tail with the controller left and right.