Retracts Setup Help

[22charlie]

Noobee question. How do I assign/configure my TX (PCM9X) to get the U/Cs to work ?

The suckers just sit on their respective belly's. For the life of me I can't get any switch assignments to work a damn! Been into the edit function for the TX,fooled around in there till I am blue in the face (not too hard I might add) The ABC's would be very much appreciated. Oh! please assume I know bugger all about TX's.

Many thanx in advance to all.

[helical]

Did you calibrate all your switches in Phoenix?

[22charlie]

Hmmmmm.....! Don't think I did. OK thanks, I will have a go if I can get up the nerve to stuff everything up again .

[22charlie]

Jeeeees! How easy was that,many thanks Helical. All is well with the world again,you are now on my Christmas card list. Just as a mater of interest I emailed Phoenix with my "problem" but the technically oriented reply left me a bit bemused. I tried to follow their hints but just ended up scrambulating the whole box and dice.
Once again many thanks. 22charlie out.

[helical]

Glad you got it resolved!

P.S. I'll PM you my address. LOL