Socal500
03-12-2008, 04:16 PM
TRADE ONLY and LOCAL ONLY. If you are asking for purchase of package, any part of package, non local trade, then STOP READING HERE.
I have the itch for nitro so Im looking for something local on a trade. As this will be with the exception of a RX, I expect the same in trade. This would include digital servos and a governor.
Trex 500 CF (yellow canopy and Align white carbon)
Metal Main Bearing Blocks (orig blocks and bearings incl)
Metal Tail Upgrade (orig tail and bearings incl)
Metal Mixing Arms (orig mixing arms and bearings incl)
Align 500L (13T installed) One extra NEW 500L
Jazz 80-6-18 ESC
JR 7703D Gyro
JR 8900G Tail Servo
Futaba 9650s on cyclic
4 Align 6S 2500 Lipos (3 flights each at 50% cap. Not broken in yet.)
Some extra parts but I will have to go through them. I know I have a couple flybars, belt, plastic bottom of frame and a few other items NIP.
I have never crash but did one bad auto and snapped a landing gear. New one put on. Then had a brown out that dropped and broke the gear again. New gear put on. Canopy has just slight chips along corners where it goes in the slot. Hairline cracks on black part of canopy from edge of battery pushing against it when I had large packs in it.
Tail boom, tail, pulley shafts are all grounded to frame. Frame and motor mount are grounded to the negative of the ESC.
I want to do this local only so the person trading can see the quality of the build and setup. I want to be able to do the same.
Shoot me a PM.
http://www.socalsurfs.com/trex500/500invert.jpg
I have the itch for nitro so Im looking for something local on a trade. As this will be with the exception of a RX, I expect the same in trade. This would include digital servos and a governor.
Trex 500 CF (yellow canopy and Align white carbon)
Metal Main Bearing Blocks (orig blocks and bearings incl)
Metal Tail Upgrade (orig tail and bearings incl)
Metal Mixing Arms (orig mixing arms and bearings incl)
Align 500L (13T installed) One extra NEW 500L
Jazz 80-6-18 ESC
JR 7703D Gyro
JR 8900G Tail Servo
Futaba 9650s on cyclic
4 Align 6S 2500 Lipos (3 flights each at 50% cap. Not broken in yet.)
Some extra parts but I will have to go through them. I know I have a couple flybars, belt, plastic bottom of frame and a few other items NIP.
I have never crash but did one bad auto and snapped a landing gear. New one put on. Then had a brown out that dropped and broke the gear again. New gear put on. Canopy has just slight chips along corners where it goes in the slot. Hairline cracks on black part of canopy from edge of battery pushing against it when I had large packs in it.
Tail boom, tail, pulley shafts are all grounded to frame. Frame and motor mount are grounded to the negative of the ESC.
I want to do this local only so the person trading can see the quality of the build and setup. I want to be able to do the same.
Shoot me a PM.
http://www.socalsurfs.com/trex500/500invert.jpg