DumbDawg
03-13-2008, 12:23 PM
Ok I have seen the 'suggested' parts list which people have suggested to have. As a total noob to rc heli's I KNOW that parts will have to be replaced.
I'm sticking to the cheaper wooden mains for now, until I'm confident that there will be a minimum blade strikes.
My question is about all the other bits and pieces say in the main rotor head assembly and such. When I break things should I replace them with cnc or stick to the plastic bits for now??
I'm thinking plastic for now for a number of reasons. I may break some pieces more often than others and its cheaper in plastic. With plastic I'll break less parts because of the torsional effects ie. less likely to bend main shaft because all the plastic will vaporise before that happens.
So... plastic or cnc... plastic or cnc???? :thinking which is suggested??
thx
I'm sticking to the cheaper wooden mains for now, until I'm confident that there will be a minimum blade strikes.
My question is about all the other bits and pieces say in the main rotor head assembly and such. When I break things should I replace them with cnc or stick to the plastic bits for now??
I'm thinking plastic for now for a number of reasons. I may break some pieces more often than others and its cheaper in plastic. With plastic I'll break less parts because of the torsional effects ie. less likely to bend main shaft because all the plastic will vaporise before that happens.
So... plastic or cnc... plastic or cnc???? :thinking which is suggested??
thx