View Full Version : EP200 Main Frame Width
trexflyer02
03-13-2008, 07:17 PM
Hi guys-
I am considering buying a Gaui EP200SE, and have a quick question ... I'm not sure if my receiver will fit in the frame! Can someone measure the frame width on the inside of the frames? I'm flying with a Futaba 7C FASST, and the receiver width is about 27-28mm. Any help would be greatly appreciated. Thanks!
Buzzkill
03-13-2008, 08:38 PM
Should fit in mutiple positions.
trexflyer02
03-13-2008, 09:34 PM
Thanks Buzzkill. I think I read in another thread that the frame width is about 31mm. Is this true?
Buzzkill
03-13-2008, 09:48 PM
31/32mm give or take a mm.
trexflyer02
03-13-2008, 10:00 PM
Thanks! Now I just have to convince myself I really want one :P
trexflyer02
03-13-2008, 11:09 PM
Alright ... so another question for you seasoned EP200 guys. What are the best blades out there for 3D? The Gaui wood blades? I intend on doing pretty moderate 3D with this thing, if I get one.
Also, it seems as though the most popular battery is a 2S ~800mah pack. I can't find any of the Gaui packs, which seem to be the pack of choice, but would this pack (http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXTCF4&P=7) be a good substitution? With 22C at hand, I don't think power is going to a problem. The size looks right to me, given the fact that the frames are about 31mm wide. Any objections?
Thanks again for any help. :thumbup:
that pack is a little long, but doesn't look too bad. frame is about 31MM wide. And that might be slightly generous. I measured with the calipers on the inside of the frame.