ChrisW
03-14-2008, 12:37 PM
$200 or trade for a Mini-Titan or T-rex 450 with motor/esc
Good condition C-Spec with OMI mod carb with dual plug Viperhead
Viperhead is a pre-production unit (clear anodizing, not blue like production units). Has an Enya#3 in the middle and OS#8 in the rear port. Carb is a 60K with 3-needles. Mods were done by OMI. (This is a 10mm bore carb, not a big-bore.)
This engine has been run and has been in a crash or two...It is a good running engine that has always been cared for and not run lean. Rear bearings have been changed every 5 or so gallons.
There is a crack at the front muffler bolt hole (crash damage)...This engine has been run for about 5 gallons of fuel since that damage occured without any problems, so it's nothing to worry about.
I switched to YS engines about 1.5 years ago...So this one has been sitting on the shelf...
Asking $200 shipped in USA or trade for a good condition Mini-Titan or T-rex 450 with motor & ESC
This is a chance to get a good strong 91 for that 3D heli...Runs great with SB16 or a MP..
PM me or call me (760)415-3833
Good condition C-Spec with OMI mod carb with dual plug Viperhead
Viperhead is a pre-production unit (clear anodizing, not blue like production units). Has an Enya#3 in the middle and OS#8 in the rear port. Carb is a 60K with 3-needles. Mods were done by OMI. (This is a 10mm bore carb, not a big-bore.)
This engine has been run and has been in a crash or two...It is a good running engine that has always been cared for and not run lean. Rear bearings have been changed every 5 or so gallons.
There is a crack at the front muffler bolt hole (crash damage)...This engine has been run for about 5 gallons of fuel since that damage occured without any problems, so it's nothing to worry about.
I switched to YS engines about 1.5 years ago...So this one has been sitting on the shelf...
Asking $200 shipped in USA or trade for a good condition Mini-Titan or T-rex 450 with motor & ESC
This is a chance to get a good strong 91 for that 3D heli...Runs great with SB16 or a MP..
PM me or call me (760)415-3833