Max2342
03-15-2008, 05:43 PM
Well i just wanted to post here how i recovered my DX-7 after PCB traces came off during desolder the voltage regulator. I know the best way is to clip the old legs from the regulator but i wanted to have it clean and everything was ok till i was thinking...lets wait with VIN and remove first the main component. Wrong decision, just because i had a hurry the heat was ok but loosen also my VIN leg and pcb traces == BAD but because it was only VIN it was very simple just connecting the red cable from the one connector on the other side of the board. I wrote a small blog with two photos.
http://remote-exploit.blogspot.com/
hope this helps someone.
max
http://remote-exploit.blogspot.com/
hope this helps someone.
max