blueviewlaguna
03-19-2008, 01:25 AM
CellPro 10S bugs or normal behaviors?
Cell One voltage (after a charge) drops after the main front panel banana plugs are disconnected (but still connected and displaying the individual voltages via the balance)
Internal resistance readings for 6S always shows cell one as 50% higher than the other 5 cells - tested this on 3 FP4900s so far.
When connecting two 3S packs, the node connector shares pin 6 (highest pin on channel one) and pin 7 (lowest pin on channel two). This seems to double the internal resistance reading for Cell #1 of the second pack, even though all individual cell voltages are displayed (no two cell connections are bridged together).
In order to change the charge amperage manually, must HOLD the mode button to get past the amperage screen, then HOLD again to get past the Battery Type Screen, then scroll up through 1C, 2C, 3C, Storage, then start at 0.1...... If I overshoot, I have to hold to get past the first two screens again. Is there some way to select the amperage directly without being forced to scroll past it?
Cell One voltage (after a charge) drops after the main front panel banana plugs are disconnected (but still connected and displaying the individual voltages via the balance)
Internal resistance readings for 6S always shows cell one as 50% higher than the other 5 cells - tested this on 3 FP4900s so far.
When connecting two 3S packs, the node connector shares pin 6 (highest pin on channel one) and pin 7 (lowest pin on channel two). This seems to double the internal resistance reading for Cell #1 of the second pack, even though all individual cell voltages are displayed (no two cell connections are bridged together).
In order to change the charge amperage manually, must HOLD the mode button to get past the amperage screen, then HOLD again to get past the Battery Type Screen, then scroll up through 1C, 2C, 3C, Storage, then start at 0.1...... If I overshoot, I have to hold to get past the first two screens again. Is there some way to select the amperage directly without being forced to scroll past it?