Snoopy6
03-19-2008, 12:09 PM
Was checking with my LHS for some servo extensions to connect Futaba S9650s to an AR7000 receiver in my TREX 500. I was told that you need to cut the little tabs off the Futaba connectors to fit the AR7000. Had never heard this (I did notice that the connectors are a tight fit). Anybody been doing this? :roll:
joehelicopter
03-19-2008, 05:44 PM
Was checking with my LHS for some servo extensions to connect Futaba S9650s to an AR7000 receiver in my TREX 500. I was told that you need to cut the little tabs off the Futaba connectors to fit the AR7000. Had never heard this (I did notice that the connectors are a tight fit). Anybody been doing this? :roll:
That's correct--use sandpaper or a file to file the tab's down:thumbup: