Sanity Check: 6S balance tap schematic...

[HELINHAWAII]

Background: I'm trying to convert two 3S packs into one 6S and plan on using a JST(Align) balance tap. I know there are conversion plugs out there to be used with a serial deans discharge cable and I have some of those coming. See link below:

http://www.hobbycity.com/hobbycity/store/uh_viewItem.asp?idProduct=6544

Why: So I can charge two 6S packs at once with my new DUO charger. And...I get bored easily when not flying during the week so I'm always in need of a project.

Will one of you experts check out the schematic I've come up with? Just trying to make sure I don't smoke something.

Thanks "Freakers" !

[HPSOV2]

Your diagram is correct.

[HELINHAWAII]

Actually, I've just learned the the connector I drew in the diagram needs to be flipped upside down.

I.E.- With the prongs on the connector facing up, the gorund will be on the right side of the connector.

I've attached the CORRECT diagram.

DON"T USE THE ONE ABOVE!!!

[HPSOV2]

Sorry mate, didn't think about the overall polarity, but that bit is fairly obvious (you picked it up).