Tail servo help

[jmb2232]

I am setting up the V-Stabi on my 600e. I loaded the 600e program from the Trex600 tab, made sure all the servos were moving in the correct direction, and leveled the swash. When I press finish setup my tail servo goes full right and just sits there. It will not hold center. I know that I must be doing something wrong and I bet there is a simple explanation. Has anybody had this happen before? Thanks.
Mike B.

[jmb2232]

I answered my own question. As soon as I exited the software and the heli was stand alone, the servo acted just like good old HH mode. Man, I thought I had messed something up.
Mike B.

[jmb2232]

Also, I adjusted the limits from the default of 64/64 to 50/50 and everything is fine.
Mike B.