12fg 2.4 and 14ch R6014 Rx and Multigov

[highland flyer]

Need help in setting up an Aerospire Multigov off the flight mode switch. I'm looking for a 3 speed setup of the Idle up switch

I read a thread about this here http://www.helifreak.com/showthread.php?t=43893

Does this also apply to this Rx? I believe the ch outputs are arranged differently to the G3 Rx's etc...

thanks Brian

P.S. I admit I'm crap at setting Radio's up so go easy on me...

[Trooper Sam]

I'll get back to you later on this, but I'm pretty sure I setup the governor on channel 10 on the 5014, and left it on 10 when I switched to 2.4. It was very easy to setup a mix with the flight mode switch, and my Multigov has worked flawlessly since that initial setup.

[highland flyer]

Just a follow Up I got the Multigov to work via the Governor menu no problem.

I set 3 different percentages in the Governer Menu as follows...100% 50% 0% with the group setting set to SNGL, this is all in Governor set to Rate 1. When you move the flight mode switch it changes to one of the above percentages that you set telling the Multigov to move from each Headspeed to the next as required. (I used the Configuration card to confirm all was working).

cheers Brian

Moving the Flight mode switch