going brushless tail and main

[DOGBONE47]

i have a cp+ stock head. i have put bl tail and main. have 6100 spek rec and 6i radio. where can i find radio programing. the radio must do mixing. also a 401 gyro. all electrinics done and working. also servo s working as well. i have reversed some of the servo s. in the radio. but now what should i do. please help.




=

[zaw]

Pos and Neg numbers might be different one which channel is reverses and which servo connected to chan 1 and 6 etc.

Mine is
A + 70
E + 70
P + 25

Pit of 25% give me pitch of -12 / + 12 @ 0 - 100% pitch.

DX6i Pitch setting is set at 50% by default and it too extreme for blade CP head, servo binding etc happens.
I use Futaba but basic settings should be the same as any other TX.

at 50% pitch is set to 0 with with slop toward the wind. BCP head have a lot of slops and I found that on mine at least if I hold the fly bar and turn the blade forward its read 0 on gauge is true 0.

Normal Throttle different from Motor to Motor i guess. I have HDX300 3800kv BL with 9T set at
1 0
2 20
3 40
4 60
5 70

I know they're not efficient for the motor but I can only fly in my basement and faster head speed destroy stuff more. If I put 8T motor rub on front servo. When I fly outside I change 4 to 75 and 5 to 90 work pretty good.

Pitch
1 35
2 45
3 50
4 80
5 100

I'm still working the best curves for me, these settings work for me so far.

Idle up
Throttle
1 100
2 80
3 75
4 80
5 100

Idle up
Pitch
1 0
2 25
3 50
4 75
5 100

If you have your motor unplugged, "Not Throttle Hold" Set throttle to lowest and if you flick the Idle up switch swash plate should move. I had to enable on my TX. I remember on my friend DX6i , Stunt pitch curve start at 50% by default.