gyro setup with dx7

[vtjeep]

ok i have a dx7 with a raptor titan .. my gyo is a g770 3d my question is it tells me to start with 62 gain 85 d/r and 50 expo.. ic were to put the expo and i think were the d/r gose but what is the gain is this the rate in the gyro sens screen im confused .. is there more info on gyro setup somewhere ? thanks

[WayneBrown]

for the titan you will use 15mm out on the arm, and about 23% gain. Use the ATV method on channel 5 with 50% expo on Rudder with ATV for rudder at 100%.
Adjust rudder ATV for piro speed, expo for sensitivity around center stick.
Verify that you are in HH by powering up, give a rudder input. If the servo moves and stays when you release the stick, you are in HH. If it goes back you are in rate mode.
Here's a brief explanation of gain comparison to using the gyro sense menu:
50% is gyro off This applies to ATV or gyro sense value.
The 62% from the manual is translated to 12% gain. (62%-50%=12%)
To utilize ATV instead of Gyro sense, add 'X' to 50% to achieve Heading Hold, Subtract 'X' for Rate mode.
Following setup tip from above, Your settings for gain would be Channel 5 ATV Low of 23% (rate) and 73% (heading hold) as a starting point. You should expect to have to reduce values to eliminate wag, and have an aggressive stop.

[Trizz]

Hay WAYNE, do you have a set up for the DX7 AR7000 g770 on knight 600e i figured i ask my stuff should be here Monday so i would like to try and get it done should it be set up to the specks of the trex 600e?

[WayneBrown]

I'll have to measure the wheel to be sure, but for a quick guess 18mm from center, and gain around 20%. Expo and rates per the 600e/n

[Trizz]

Thanks you so much any spec that you have for this unit as per the dx7 and the jr770 for hh-ff and so-on is greatly appreciated

[kljw]

hi,
do you have a setup for the jr770t and 8900 on a trex 600?

be good if you could help.

thank you
keith

[WayneBrown]

hi,
do you have a setup for the jr770t and 8900 on a trex 600?

be good if you could help.

thank you
keith
that setup is in the manual. works well.
Do you have a manual, or should I post a copy?

[kljw]

hi, sorry for the delay in getting back, but other things take up time, i have a copy of the manual, and i am assuming you mean the JR manual.

i am confused about what setting to enter into the transceiver, can you help?

thanks in anticipation

cheers
keith

[viper0173]

ok heres on that i cant seem to find/ sny clue on the set up for trex 500 using g770 and the 9650. im getting tail bouce bad.

[Gernejr]

Viper, Tail bounce is from low head speed. Rise your head speed 13 pinion normal mode 80-90-100.

[viper0173]

its not bpouncing up and down it bounces back aafter tail input

[srhadden]

What is the difference between using the GEAR switch and setting the gear switch to GYRO?

It works fine, but what is the GYRO setting for?