phoneman
03-24-2008, 07:55 PM
I am hoping one of you gyro intelligient fellows can help me sort out my trouble. I have a brand new 611 gyro-a brand new 9303 2.4 radio-a brand new Duralite Geminii regulator. This is how I have it all connected ( per the fellow at Duralite )--the rudder servo is plugged into the servo port on the gyro--the rudder input lead from the gyro is plugged into the 5.3 v outlet on the Geminii--the aux gain lead from the gyro is plugged into the gyro channel on the rx ( the red lead has been removed from this lead per the instructions )--the lead from the Geminii is plugged into the rudder channel on the rx---when connected this way I get 5.3 volts to the tail servo but the gyro does not initialize and I get no rudder servo response. I have swapped the wires around and I am able to get the gyro to initialize but I end up with 5.7 volts going to the tail servo. I am not familiar at all with any of this equipment so I hope I'm just missing something somewhere. Any help will be greatly appreciated as I am about out of ideas.