550 question

[michael88997]

ok one more question... ive been searching post and im confused... on the head there are the top arms on the yoke, seesaw and mixing arms all have different holes to put the ball links into. what combo gives you most 3d capabilities? right now the mixing arms are on the outside, the seesaw are in the middle, and top are on outside

[mjdee14]

Michael..

look at odie's thread and download the manual on the below link.....will answer all your
questions on what holes do what....and has a graph to boot....

http://www.helifreak.com/showthread.php?t=67117

[odieser]

only you must understand michael88997 that the head on the Guai is not the same as the Avant Head that mjdee 14 has sent you to but it will give you a good idea of the principles I suppose. I havent been able to find anything better to refence yet.
Mark

[Hawk18052]

Alittle confused, why the red lock tight? the blue is much stronger. I'll do what ya say though just a bit puzzeld.

Downloaded the "how to use attachments" video but it really only covers Jepgs or giffs. what about a full video or did I miss that part? Just need to know since I already have video to upload.

end of line,
Hawk

[mysticmead]

red loctite is stronger.. and is normally permanent compared to blue..

as far as videos... upload them at youtube.com

[michael88997]

ok so everything on the outside except the flybar is on the inside... and yes red locktight is alot stronger than blue... if you use red you have to use a torch to heat up the metal to get it off

[michael88997]

well i used readyheli.com headspeed calculator for the hurricane and it says with the 42t and 14t pinon ill be at 2259 at 100% Efficiency and 2146 at 95%

with the 15t ill be at 2420 at 100% and 2299 at 95%... so im going to wait until i get the cnc grips before i change out the gears because i don't want to throw a blade 2 days before i get the grips