0KEWL
03-25-2008, 05:42 PM
Hi there,
I got my DSX9 (intl. version of 9303) today (very nice!) but I am facing one big problem I don't have any clue about. First thing I did with the radio was to change mechanics (spring & ratchet) to support mode 2. This worked fine for me.
Now here's the problem: Although I have set up a linear pitch curve (IN value is the same as OUT value for the whole range), the output monitor is showing a min pitch value of about -120% and a max pitch value of +80% (the same is shown by Vbar software). Stick mechanics seem to be ok, as the pitch curve submenu shows a minimum stick movement value of 0 and a maximum value of 100. All other parameters, i.e. Expo, DR, others are unset. Swashtype setup is "1servo" as the Mikado Vbar doesn't want any mixers to be set up in the radio.
Can you please explain to me how to receive correct pitch output signals from -100% to +100%? I would appreciate your help!
Thanks & Cheers
Lars
I got my DSX9 (intl. version of 9303) today (very nice!) but I am facing one big problem I don't have any clue about. First thing I did with the radio was to change mechanics (spring & ratchet) to support mode 2. This worked fine for me.
Now here's the problem: Although I have set up a linear pitch curve (IN value is the same as OUT value for the whole range), the output monitor is showing a min pitch value of about -120% and a max pitch value of +80% (the same is shown by Vbar software). Stick mechanics seem to be ok, as the pitch curve submenu shows a minimum stick movement value of 0 and a maximum value of 100. All other parameters, i.e. Expo, DR, others are unset. Swashtype setup is "1servo" as the Mikado Vbar doesn't want any mixers to be set up in the radio.
Can you please explain to me how to receive correct pitch output signals from -100% to +100%? I would appreciate your help!
Thanks & Cheers
Lars