PDA

View Full Version : remote receiver question


t-driver
03-25-2008, 06:38 PM
i'm about to get a spectrum air module for my JR RADIO
it comes with a complete (2 pieces) ar7000 receiver.

my question.
suppose my model is very small and there is no place for the remote receiver,
can i use only the main receiver without the remote one?

odieser
03-25-2008, 07:09 PM
trade it in on the ar6100 one piece for smaller models

t-driver
03-25-2008, 07:16 PM
it was a hypothetical question,

does the main receiver work by itself using only one channel.
or must both be together in order to work at all?

Pinecone
03-25-2008, 09:18 PM
No, the AR7000 will not work without the satellite Rx.

The AR6200 will work without the sat Rx.

But AR6100s are only $41.

t-driver
04-05-2008, 05:57 PM
No, the AR7000 will not work without the satellite Rx.

The AR6200 will work without the sat Rx.

But AR6100s are only $41.


did you try it out? (ar6200)
i'm reading in rcg that no dual receiver will work as a stand alone without the satellite...
at least not without a trick. (after connection remove the satellite) but that's too extreme,
it won't reconnect if signal is lost.

Pinecone
04-10-2008, 04:38 AM
I have not tried it yet, but I have heard reports both ways.

So it MAY work without the sat. :)