Thunder Tiger Zero Alpha Governor

[Socal500]

I have calibrated this per the instructions. Verified that the LED goes out when the magnet passes the sensor. When in normal mode I am above 25%, looking at my curve about 70%. On stnt 2 I have gov percentage set to 70%, which according to the TT documention and the number of blinks on the LED, puts me at about 18,000 plus.

Problem is when I switch into lock mode (stnt2) the throttle drops way down to idle.

Any help?

[vandelescrow]

I dont have the Zero Alpha but the Aerospire Multigov, maybe I can help. What radio are you using? I have the JR9303. For governor you have to go into the advanced settings on the radio to activate it. Make sure your end points are at 100 both ways on channel 5 prior to activating, you will not be able to change it after activating governor on the radio. Then in normal settings, go to the governor function. You will see 4 entries. On the Multigov, you need to have the programing LCD plugged in and looking at (I think it's called mode). Have your transmitter switches so your in normal mode and make sure the display says normal, If not adjust the setting in the transmitter to either :"0" or "100" for normal mode. Then switch the radio to stunt 1, change the setting in the radio to "50" for stunt 1, ensure the display on the governor shows stunt 1. What ever you have normal set to, make the setting in your radio the oposite (I.E. if normal is "0" stunt 2 will be "100". Switch the radio to stunt 2 and the display on the governor should say stunt 2. Now set the throttle hold to the same setting you have for nomal mode.

For the Multigov, this is how you tell the governor what flight mode you are in.

I hope this helps.

[Socal500]

Thanks.. I already have my modes set. The problem is the sensor was to close. I backed it off a bit and its working correctly now.