sc204
03-26-2008, 10:37 AM
Should the washout arms be level at mid stick (0 deg pitch)? It seems that the rotor head is set up for 0 deg at 2/3 or 3/4 throttle stick position. In order to level the washout assembly at mid stick you have to legnthen the rod with the bent link on it. It seems that there is not much thread left left in the plastic lnks whent this is long enough.
Has anyone else found this or am I doing something else wrong?
Second issue is with the main gear. It seems to wobble as it turns. Best seen when running up the heli at low throttle. Again is this usual or a bad gear? On the subject of main gears is the large collar above the gear intended to be inserted with the turned down section pointin up or down?
(I know that was three question)
Thanks,
Stuart
Has anyone else found this or am I doing something else wrong?
Second issue is with the main gear. It seems to wobble as it turns. Best seen when running up the heli at low throttle. Again is this usual or a bad gear? On the subject of main gears is the large collar above the gear intended to be inserted with the turned down section pointin up or down?
(I know that was three question)
Thanks,
Stuart