View Full Version : GV1 On/Off Switch
alex.venom
03-27-2008, 04:45 PM
Hello there!
I programmed my GV1 Governor On/Off switch to SB. That's a 3 position Switch.
It's working perfectly but the On/Off sequence is like
Up: OFF
Center: OFF
Down: ON
And I wanted it to be
Up: OFF
Center: ON
Down: ON
I tried the Function menu, where I choose the key to operate the On/Off function, but there's no "On Position" in that screen.
Is there any way to change it to the way I want?
Thanks!
MarkD
03-27-2008, 05:03 PM
I think you have to set that on the GV-1.. Mines the same as yours but using SW-A and I can't see a On-OFF screen either for that control
DavidH
03-27-2008, 05:32 PM
Hello there!
I programmed my GV1 Governor On/Off switch to SB. That's a 3 position Switch.
It's working perfectly but the On/Off sequence is like
Up: OFF
Center: OFF
Down: ON
And I wanted it to be
Up: OFF
Center: ON
Down: ON
I tried the Function menu, where I choose the key to operate the On/Off function, but there's no "On Position" in that screen.
Is there any way to change it to the way I want?
Thanks!
Go into the menu in the transmitter for Reversing the channels. Reverse the channel that is controlling the On/OFF on the GV1. Then the switch will be ON/ON/ Off
David
steve90210
04-07-2008, 08:12 PM
I have the same question and have been waiting for an answer on the flyers club forum.
Does reversing menu allow you to change each assignment for each position, as if you wanted to change the position to:
on
off
on
I thought you could do this in the funtion menu but did things change after the updates?
DavidH
04-08-2008, 10:04 AM
I have the same question and have been waiting for an answer on the flyers club forum.
Does reversing menu allow you to change each assignment for each position, as if you wanted to change the position to:
on
off
on
I thought you could do this in the funtion menu but did things change after the updates?
Might be able to make each position what you want on the 12's and 14 transmitter. But on the 9Z and others I have used. You can only reverse the operating direction. ON OFF OFF or OFF OFF ON.
David
steve90210
04-08-2008, 08:52 PM
Thanks for the response, Ya on the 12z I was able to change switch position asignment, I can't get to those menu's anymore (or more likly I just can't remember).
alex.venom
04-11-2008, 04:54 PM
I could find a way today!!!
Go to the Model Menu
Go to the AFR screen
On the Left, click the channel name (mine was default by AILERON, but can be any channel)
Choose GOV2 channel
Back on the grapics screen (AFR), set the points A and B from -100, 0, +100 to +100, +100, -100 (note the signals!)
That made my OFF,ON,ON works!
steve90210
04-11-2008, 10:31 PM
Nice, thanks for posting a solution.
I just looked on futaba flyers club and finally got an answer, it was the same solution. I liked the other menu they used to have, was a lot easier.
Thanks
for the gv-1 i dont even touch my radio i do it all on the governor and so far seems to work fine for the flights i have on it. and without using the radio it seems really really simple.