Gohbee Stinger 90

[mvjester]

Is there anyone out there that has had better luck with this helicopter than me?? My maiden flight sucked for the fact that I was 3 foot off the ground when the tail rotor bearing fell apart and then slung a tail blade, well the helicopter went into spin which i shut the engine down and tried to auto it in but a spinning helicopter doesnt land nice. so i spent the money for the repairs which gohbee give me the tail bearing pieces and then took 20% off the rest of the order. Now the oneway bearing is out so now i have to buy a new clutch and this is really starting to stink.. Im not at all happy.. for the money I spent on this helicopter I should not have to fix anything right now.I haven't even burned a gallon of fuel through it yet and it says before the OS engine is broke in you have to burn a gallon or two thru it before engine will be broke in..
If anyone has one of these helicopters please tell me what raptor 90 parts are interchangable with it or just please give me some advice.. thank you much on any input..

[tz250w]

I don't know anything about it but just looking at their home page...

"Just as with our 30 & 50 Size Helis, most components below the swash plate will interchange with a Raptor 90."

[mvjester]

thanks tz for your input i'll check it out. maybe some raptor parts will be better.

[Ray Fernandez]

Supposedly, all the parts sra compatible. The only difference is from the swashplate up to the rotorhead. These parts aren't interchangable with Gohbee.

[mvjester]

well i heard from gohbee manufacture and they are replacing oneway bearing free of charge.. Which makes me a little happier.I would like to say that they do have the best customer service that i have ever dealt with. now lets hope nothing else goes wrong with this heli cause it is a nice looking bird..