Phoenix calibration not sense right stick

[Cowboy1442]

I installed Phoenix this afternoon on my PC. The installation went flawlessly. However, when I started Phoenix, connected my Spektrum DX6i and went through the calibration program I noticed that recognized my left stick (throttle/collective) but does not sense or recognize my right stick (cyclic).

I have set up a new model (model 3) in the DX6i and have set my swash mix to 0,0,0.

My DX6i works fine controlling my Blade 400 and T-Rex 500, so I'm guessing that the USB connector (standard JR) is defective unless I am missing an important set-up step.

I would appreciate your suggestions.

Thanks!

[tj69]

i DON'T KNOW ABOUT THE DX6 BUT I RECON IT WOULD BE THE SAME AS DX7.
MAKE SURE IT IS SET UP FOR PPM THAT IS HAVE ONLY 1 SERVO SET UP FOR THE SWASH MIX...
HOPE THIS HELPS:thumbup:

[Ade_Law]

it sounds like you have the swash type set to 120 deg CCPM you need to set this to 1 servo.

Ade

[mharpo]

Also, you may need to calibrate more than once. It takes 2 or 3 times for mine on occasion.