View Full Version : 5265mg servo horns
nbjeeptj
03-28-2008, 10:42 PM
i have hi tec 5625mg servos on my 600n I have flown it for a while with the red cross servo horns the problem is that the spacing was off by 1 mm either way so I ordered the align servo horns for hi tec servos and went to install and they seem a little loose has any one tried these.
mattkreps
04-10-2008, 01:54 AM
i have them of the jr 8717s and the work perfect
aussiemick
04-10-2008, 02:35 AM
Mine were also a bit loose till the fixing screw was tightened down then no problem anymore.
Mick
CoronaL
04-10-2008, 09:23 AM
use the red cross horns at 15mm. The MG Hitecs I hear won't fit correct with the Align horns. The Nylon or HB versions would work fine from what I'm told
nbjeeptj
08-18-2008, 10:44 AM
i have hi tec 5625mg servos on my 600n I have flown it for a while with the red cross servo horns the problem is that the spacing was off by 1 mm either way so I ordered the align servo horns for hi tec servos and went to install and they seem a little loose has any one tried these.
I posted this a while back and the loose fit of the horns got me yesterday I had one slip and the heli was a hell of a lot of fun to get to the ground. even thou they lasted 5 months and probably 120 flights I would not use them if they dont fit right. I belive they were made for plastic gear servos not metal ones (why in the world Align would sell horns for plastic servos not metal gear is crazy) I guess I will get some red cross horns on go back with them.