Spectrum RX power up glitch

[Gary L.]

Hi,
I just bought the spectrum module for my 10x radio installed the RX in my Trex 600 when I turn on the power for the receiver all my servos go nuts and reach for the end of their travel and stay there for about 2 or 3 seconds then they go to the normal programmed position. The radio is on and I have tried rebinding the RX to see if there was any difference there is not. My question is, is this normal for this receiver to allow the servos to go helter -skelter when powered on it is the 9 channel that came with the module.

Thanks,
Gary

[Pinecone]

I assume you did the binding with the sticks in neutral positions?

And you followed the binding instructions?

If so, your Rx may be bad. I would call Horizon.

[Gary L.]

Thanks for the reply Pinecone

Yes I followed the instructions for binding thru the an on/off switch with the little jumper but it did not have a DSC wire like JR switches do, after noseing around thru the forum I am going to try connecting the bind jumper directly to the RX and the switch to a spare servo port. If this does not work I'll send it back to Horizon.

Thanks Again,
Gary

[simchippy]

Wasn't there a notice about some analog servos causing this? Can't remember but I read something that sounds like the problem your having.

Sim