ROTOMATT
03-30-2008, 09:54 PM
Had fellow helifreak member and good stick Mike C down today to check set-up of first real Helli mx450xs. after checking basics he was hovering and noticed some uncommanded control inputs,. (throttle to cyclic/elevator). after rechecking all programing there are no flight modes active unit was set up for basic hovering/flight only no stunts or 3d. Program mix 1 had values set in it but we had never input any values into it or activated it? this was new model in radio memory and was reset prior to programing. Also found that throttle setting in throttle hold changed, was set for no/zero throttle (inactive motor) for easy pitch checks and adjustments( and had been used to adj pitch with no motor).Value had changed to low throttle setting (motor became active) even though set parameters where still the same. This is my first computer radio and it has the aircraft switch layout but the Helli programing is the same, I took my time programing unit. So these unwanted programing changes have left me a little concerned. I will record all model settings and reset the model in radio memory then reprogram but to me this is not a fix.Any Help Is Welcome Thanks Matt