dubel
04-01-2008, 01:46 AM
I recently put my 401 in my dragonus II and it is centered and working; however, when I start pirouetting and stop suddenly, the tail does not stop on a dime. I had it working better in my mx 400. Also when I spool up, and when I cut the power, I get a lot of shaking and bouncing- feathering shaft, main shaft, and flybar are all good. Any help with these problems? Thanks!
michael88997
04-01-2008, 03:47 PM
make sure your delay is set to zero... if it is try to turn up your gain until the tail wags then turn it back down a little
dubel
04-01-2008, 04:43 PM
my delay is set to zero and and I am going right now to adjust the gain. What do think the vibrating is, it happens in low rpms when I spool up and slows down.
michael88997
04-01-2008, 04:52 PM
most likely your blades arn't tight enough...