Help in Trimming Beam E4

[Ice93]

I'm currently running a Beam E4. I have already setup and leveled the swash with a swash leveler. Apart from that, I have also checked the CG of the bird (Slightly tail heavy with canopy and lipo).

However, when I bring it into a hover, the bird has a tendency to nose down and roll a little to the right) Question is...is this normal? This shouldn't happen if I level my swash right?

How do I go about correcting this? Should I just adjust the trims or should like adjust the linkage rods on the swash?

Will appreciate any tips or advice.

[ducannn]

Have you check the tracking of your blades? If so try triming it out on the radio... you can always set back to zero on the trims.

David