Increasing servo speed

[Eyefly]

I just set up my logo 500 on the simple screens and noticed it is a bit sliggish on the roll and pitch. I am used to very little latency with my dx7 system. is there a way to make the servos respond quicker?

[markjj]

Wait till it's airborne!!!! the servo speed on the ground is way slower than the response when flying.
Good luck.

[Eyefly]

I did. When in hover, the servos feel lethargic. I want snappier response. I will try to increase the cyclic rate to see what happens. I dont know what else to change in the set-up.

[OICU812]

Put your aileron and elevator stops to 35 each, put your aileron and elevator cyclic speeds to 6 each, and on the CCPM menu put your cyclic gain to 120. Make sure you also have your cyclic ring to your max before bind, usually somewhere betwee 65 -80 depending what servos you are running and what exact hole on the servo arm...