tienman04
04-03-2008, 08:57 PM
Just got the ALIGN 6S to fly the Trex and it doesn't seem to work.
When I plug in a 3S to power the Trex 500, the motor would spin up fine, but when I plug the ALIGN 6S in, the motor would not work correctly. I reseted the ESC too, it still didn't work. My settings are:
1. Brake-disabled
2. Mid-Timing
3. Middle cut-off
4. Helicopter 1 (soft start)
5. Quick speed
6. 6.0V
The motor would start to spin clockwise and counterclockwise for a few seconds, then it stops. I noticed the ESC and motor got a little warm also. It wasn't hot but just warm. Any ideas?
Heres a video to show it:
http://www.youtube.com/watch?v=hdlYz4ERuAA
Well...I messed with it some more and the only way I can get it to spool up is to use Airplane mode for start up. I think I will have to do this to fly the heli because I tired everything else. I think I will be the only one that would use Airplane mode for the heli.
When I plug in a 3S to power the Trex 500, the motor would spin up fine, but when I plug the ALIGN 6S in, the motor would not work correctly. I reseted the ESC too, it still didn't work. My settings are:
1. Brake-disabled
2. Mid-Timing
3. Middle cut-off
4. Helicopter 1 (soft start)
5. Quick speed
6. 6.0V
The motor would start to spin clockwise and counterclockwise for a few seconds, then it stops. I noticed the ESC and motor got a little warm also. It wasn't hot but just warm. Any ideas?
Heres a video to show it:
http://www.youtube.com/watch?v=hdlYz4ERuAA
Well...I messed with it some more and the only way I can get it to spool up is to use Airplane mode for start up. I think I will have to do this to fly the heli because I tired everything else. I think I will be the only one that would use Airplane mode for the heli.