PDA

View Full Version : MAH 425mm CF Blades - new outlook


docjoe
04-04-2008, 10:56 AM
I just wanted to go on record stating that I had a previous bad experience with a pair of 425mm MAH blades for my Lepton/TRex500. These must have been an old pair of blades. After discussing with Jeff at MRC, I sent my old pair of blades back and they sent me a new set. The new set is 59g per blade (1g less than my SAB blades). These blades did not exhibit the same rotor disk loading and bogging during hard 3D (which I had at one time attributed to the Lepton and then the blades). These blades are great. Tracked online immediately, felt stiff and responsive. The cyclic may have been a little slow. I still need to put it through its paces but definitely a different blade than the 2 pairs I had previously.